Forum gratuit : A place for CHRFab customers both current and potential can share information and get technical advice throughout the Northstar and LS Engine Community.
forum, gratuit, chrfab, northstar, cadillac, #hotrod, engine, fabricate, motor
Henham is a dirt track oval. Meetings fortnightly from March untill October
henham, raceway, banger, racing, #hotrod, mini, formular, autograss, essex
I have a 96 craftsman rear engine rider I used as a offroad until the tranny cracked... Had a 10hp craftsman flathead, ran good but I started working on the Deere cuz I had no tranny and just let it sit. Started gettin the idea of makin it a "hot
well got this troy built took it down to the frame it was exstended 12in then and another 3 feet on the back for there room for the bed to be put on so far 3 mtds are going into one gunna make a chassis out of bed frame to sturdy the back and after it al
Alrighty, then! High time I got off my @ss and got into one of these build-off deals! So here's the scoop- I'm entering my mini build! The basics: I'm building a rat rod out of this vintage Eaton's Viking Holiday. It will be powered by my
broke her in right..63mph and still pullin http://www.youtube.com/v/jIXxphFvzgw?
Whell been a while since i been on here and i finally got me a mower.... I got a fairly good cond. crafstman 2 12hp.. down sides it turns starter over as soon as u hook the batery up and it dosnt like to go into reverse. Maid a weight rack and put some
What do you guys think? Lowerd down in the front so far!