Forum gratuit : A place for CHRFab customers both current and potential can share information and get technical advice throughout the Northstar and LS Engine Community.
forum, gratuit, chrfab, northstar, cadillac, #hotrod, engine, fabricate, motor
Henham is a dirt track oval. Meetings fortnightly from March untill October
henham, raceway, banger, racing, #hotrod, mini, formular, autograss, essex
What do you guys think? Lowerd down in the front so far!
well got this troy built took it down to the frame it was exstended 12in then and another 3 feet on the back for there room for the bed to be put on so far 3 mtds are going into one gunna make a chassis out of bed frame to sturdy the back and after it al
Whell been a while since i been on here and i finally got me a mower.... I got a fairly good cond. crafstman 2 12hp.. down sides it turns starter over as soon as u hook the batery up and it dosnt like to go into reverse. Maid a weight rack and put some
Alrighty, then! High time I got off my @ss and got into one of these build-off deals! So here's the scoop- I'm entering my mini build! The basics: I'm building a rat rod out of this vintage Eaton's Viking Holiday. It will be powered by my
broke her in right..63mph and still pullin http://www.youtube.com/v/jIXxphFvzgw?
I have a 96 craftsman rear engine rider I used as a offroad until the tranny cracked... Had a 10hp craftsman flathead, ran good but I started working on the Deere cuz I had no tranny and just let it sit. Started gettin the idea of makin it a "hot